DC USA Approved ET25 Electrified Storeroom Trim With Key Overide, 6 Pin C Keyway Mortise Cylinder, For PD25/PD26, Cal Royal 7700 and Von Duprin 98/99 Exit Devices
The DC USA Approved ET25/26 series exit trim is perfect for stairwell conditions or applications where electric pullback of the exit device's latchbolt is cost prohibitive or not required. This is especially practical in applications where fire/life safety codes require a fail safe condition which is not an option with electrified latch pullback devices. The ET25/26 is compatible with the DC USA Approved PD25, Cal Royal 7700 series, & Von Duprin 98/99 R/V series!
The DC USA Approved electronic ET25 exit trim is perfect for stairwell conditions orapplications where electric pullback of the exit device's latchbolt is cost prohibitiveor not required. This is especially practical in applications where fire/life safety codesrequire fail safe condition which is not an option with electrified latch pullbackdevices. Because the current draw is quite low there is no need for a more expansivepower supply to provide the surge current.
ET25EL - storeroom (fail safe): Outside lever locked (EL) electronically. Switched power allows outsidelever to retract latch(es). Outside key momentarily unlocks outside lever toretract latch(es). Inside push pad is always free for immediate egress.
ET25EU-storeroom (fail secure):Outside lever unlocked (EU) electronically. Switched power allows outsidelever to retract latch(es). Outside key momentarily unlocks outside lever toretract latch(es). Inside push pad is always free for immediate egress.
Features:- Continuous duty solenoids used to insure trouble-free operation
- Internally mounted solenoid to ease installation (no special door prep required)
Options:- Available Fail Safe (Electrically Locked) or Fail Secure (Electrically Unlocked)
- Voltage options - 12V or 24V (AC/DC)
- REE - Request to Enter switch available
- CRU2 - Current Reduction Unit to improve solenoid life in continuously on applications
- CRU2i - The intelligent CRU2: automatically detects DC input voltage between 12 to 30 volts and converts it to operate our 12V exit trims. Additionally, it adjusts the current to the solenoid allowing the exittrim to run cooler and last longer without any manual adjustments.
Specifications:- Operating Voltage - 12 or 24VAC/DC (+or- 10%) (must specify 12 or 24 volts when ordering)
- Amperage - 12V = 250 mA / 24V = 150 mA
- Solenoid coil resistance - 12V = 49 Ohms / 24V = 159 Ohms